Junior Garage Door Holder Model 1012 from Cookson Hardware.
Product Reference: 10120000BK
Junior garage door holders are designed to hold open lightweight side hung single doors in out buildings or garages, at approximately 90 degrees. Suitable for fixing to the underside of a minimum 75mm wide lintel. The door is released from the held open position by pulling the pull cord. Ideal for situations where the door cannot be propped open, the holder engages and will hold the door open until the cord is pulled to release it. This product is not suitable for fire doors. Supplied complete with fixings. Sold in single units (half pairs).
380mm overall length.
- Open the door to right angles
- Fix bracket "A" to lintel at distance of 300mm from the centre of the hinge pin to the centre of the swivel plate. Ensure bracket is fixed with front edge of the top swivelling fixing plate parallel to, but set back from, the door rebate
- While the door is open at right angles, fix bracket "B" to the door ensuring the bar is horizontal
- If the door is required to open wider than 90 degrees, both brackets must be moved nearer to the hinge
Fixing diagram for 1012 garage door holder for wide lintels (minimum 75mm wide lintel)
Click the image above to enlarge.
Images may vary slightly than the product shown depending on current stocks.
|Similar products can be found in these categories:|
Door Holders & Stays
Garage Door Stays|
All Perry Hinges and Ironmongery Products